Challenge
The customer needed a very short cycle on a thin-wall cup while keeping label placement stable and minimizing cup deformation.
Food packaging
Packaging IML Yogurt Cup Mold
Thin-wall IML yogurt cup mold built for fast cycle time, label stability and consistent stacking.
Solution
JFMOULD tuned high-speed cooling, strengthened venting and aligned the cavity design with the IML robot pickup sequence.
Result
The production line reached repeatable stacking performance and hit the target cycle for yogurt cup output.
Program Notes
This program was driven by output, stackability and robot-friendly label handling for a fast-moving dairy packaging line.
Start Your Mold Project
Get Free DFM Review
Share your drawing, sample or idea and we will reply with practical mold feedback within 12 hours.
Packaging Packaging Cutlery Spoon Mold
High-cavity disposable spoon mold tuned for fast filling, crisp shutoff and stable startup quality.
- Challenge
- The spoon had to run at high speed with consistent fill in many cavities while avoiding flash on the thin handle edge.
- Result
- The line achieved stable short cycles with acceptable stiffness and low reject rates during startup.
Packaging Packaging Takeaway Container Lid Mold
Thin-wall takeaway container lid mold designed for lid flatness, stackability and repeatable snap-fit.
- Challenge
- A large thin-wall lid needed flatness, stackability and reliable snap-fit performance without whitening around the seal ring.
- Result
- The customer achieved a repeatable snap-fit with smooth de-nesting and reduced startup scrap.
Packaging Packaging Round Tub Mold
Round food tub mold focused on wall balance, glossy finish and dependable stacking for filling lines.
- Challenge
- The tub required even wall distribution, glossy cosmetic finish and stable stacking for cold-chain food packing.
- Result
- The customer launched the new tub family with smooth line validation and low reject rates.